HireLV Handbook › Defaults › Ubiquiti › UniFi APs/switches

Verified 2026-10-17

UniFi APs/switches default installer code and reset

Suggest a correction

Suggest a correction

A free account is required. Reports stay private until a correction is published.

Default codes are for authorized installers. Change defaults at commissioning. No bypass or unauthorized-access instructions.

Ubiquiti UniFi APs/switches. Last verified 2026-10-17 against Help Center.

Defaults Flag

ssh_recoveryui/ui (older: ubnt/ubnt); adopted devices use controller-set credentials
Default IP192.168.1.20 (recovery/unadopted)

Reset

Hold reset 5-10 s while powered.

Credentials changed from ubnt to ui on newer firmware.

Questions

What is the default installer code for UniFi APs/switches?

ui/ui (older: ubnt/ubnt); adopted devices use controller-set credentials

How do I reset UniFi APs/switches to factory defaults?

Hold reset 5-10 s while powered.

What is the default IP?

192.168.1.20 (recovery/unadopted)

Why is my installer code not working?

It was probably changed at install. Use the manufacturer reset, not a bypass.

Source: Help Center

Planning aid only. Values are typical and vary by manufacturer, code edition and jurisdiction. Verify with manufacturer data, NEC/NFPA/TIA and the local AHJ. HireLV is not liable for designs based on these tools.