HireLV Handbook › Defaults › Axis › Network cameras (AXIS OS)

Verified 2026-10-17

Network cameras (AXIS OS) default installer code and reset

Suggest a correction

Suggest a correction

A free account is required. Reports stay private until a correction is published.

Default codes are for authorized installers. Change defaults at commissioning. No bypass or unauthorized-access instructions.

Axis Network cameras (AXIS OS). Last verified 2026-10-17 against t10118032 rev 2604.

Defaults Flag

usernameroot
passwordnone - set on first access
Default IPAXIS OS 11.11 and earlier: 192.168.0.90/24 if no DHCP. AXIS OS 12.0+: link-local 169.254.x.x.

Reset

Unpower the camera, hold the control button and reapply power, keep holding about 15-30 s until the status LED flashes amber, then release. Or use Maintenance > Factory default.

Default IP changed in AXIS OS 12.0.

Questions

What is the default installer code for Network cameras (AXIS OS)?

root

How do I reset Network cameras (AXIS OS) to factory defaults?

Unpower the camera, hold the control button and reapply power, keep holding about 15-30 s until the status LED flashes amber, then release. Or use Maintenance > Factory default.

What is the default IP?

AXIS OS 11.11 and earlier: 192.168.0.90/24 if no DHCP. AXIS OS 12.0+: link-local 169.254.x.x.

Why is my installer code not working?

It was probably changed at install. Use the manufacturer reset, not a bypass.

Source: t10118032 rev 2604

Same product

Planning aid only. Values are typical and vary by manufacturer, code edition and jurisdiction. Verify with manufacturer data, NEC/NFPA/TIA and the local AHJ. HireLV is not liable for designs based on these tools.